T1000-OEM

 

The T1000-OEM is a liquid/solid separator and automatic self-cleaning filter designed to remove Ultra High and Variable Total Suspended Solids (TSS) from a fluid stream for Industrial Applications. Each filter unit contains a motor-driven, spiral-shaped brush that continuously cleans collected debris from inside the filter element. Solids collect at the bottom of the filter housing to be expelled through an automatic purge valve or a continuous concentrate stream. The system does not require high pressures to operate and performs at very low differential pressure. No backwash, cross flow or booster pumps required.

Contact Us | Download Spec Sheet

 

Technical Specifications for Model SWT T1000-OEM

Specification Range
Inlet: 3” Class 150 ANSI Flange
Filtrate Outlet: 3” Class 150 ANSI Flange
Purge Outlet: 2” Class 150 ANSI Flange
Max Flow: 1090 m3 /day (200 gpm)
Filtration Rating: 15 – 100 micron
Max TSS: 15,000+ ppm
Max Operating Press: 10.3 bar (150 psi) @70°F
Min Operating Press: 0.35 bar (5 psi)
Max Temperature 90°C (190°F)
Head Loss: <0.1 bar (2 psi)
Drive Motor: 5 hp, 3-Ph, 230/460VAC

MATERIALS OF CONSTRUCTION

Part Material
Wetted Components 304 SS, Nylon 6.12
Elastomers Buna-N, EPDM or Viton
Filter Elements 316 SS

Performance Specification

The spiral shaped brush is designed to rotate continuously, so there is always less than 1 psi head loss across the filter screen. Flow through the filter unit is limited by both solids loading and hydraulic loading on the screen. Flow rates listed below assume a viscosity of 1.0 cP and TSS up to 1000 mg/l. A control system can be purchased which will monitor the solids build up in the housing and open the purge valve when necessary. The unit should be plumbed with a 5psi cracking pressure check valve on the effluent. Operating pressure in the 5 to 20 psi range is optimal, though the unit is capable of operating at 150 psi.

 

Applications of the Model SWT T1000-OEM

  • TSS and BOD Reduction
  • Recycling of Secondary Wastewater
  • Protection of Monitoring Equipment
  • Nozzle Protection
  • Bearing and Seal Protection
  • Wastewater Filtration

Flow Rates for TSS up to 1000 ppm

Note: The higher the solids, the higher the perceived apparent viscosity. At TSS above 1000 ppm, lower flow rates are required to avoid fouling of the filter screen

Filter Screen Nominal Filtration Rating (microns) Max Flow Rate (gpm, [m3 /hr])
SWT810-FE-BB 15 100 [22.7]
SWT810-FE-GG 20 133 [30.2]
SWT810-FE-YY 25 165 [37.5]
SWT810-FE-RR 50 200 [45.4]